You are receiving this because you commented. I could set it up so that when you send the play-clip command, it toggles the single-clip mode on before playing, and then when you send a normal play command, it toggles it off, or I could make it so that you can toggle single-clip mode on and off yourself using a command like /atem/hyperdeck/#/single-clip. Ok, so looking at the SDK I have the ability to toggle a single clip playback mode on and off. Open up the preferences panel and go to 'MIDI Sync' panel. Subject: Re: Hyperdeck Play Command needs Refinement ( #178) For Live 9 users, see faq 4 After the folder has been copied, plug-in your Launchpad in the computer and start Ableton Live. If I remember correctly, I think all three of those were options when I glanced a the SDK a couple of weeks ago. It supports sending and receiving Open Sound Control and MIDI messages over Wi-Fi and CoreMIDI inter-app communication and compatible hardware. If you want to play all clips once, you can do that. TouchOSC is a modular OSC and MIDI control surface for iPhone, iPod Touch and iPad by hexler. If you want one clip, you can set single clip. Gives more flexibility for a wider range of playback options. I prefer the idea of being able to set it yourself. I have searched high and low and tried many different things to try to get only a single clip to play back and have had no luck.
Would like to know if there is already a solution for this. We have to make sure that someone doesn't miss pushing a button at the right time to end the stream without picking up the next clip, which would be the recording of that day's service in most instances. But since one of those videos is triggered in the middle of a section when Ableton Live isn't being used, and should be the last thing sent to our stream, not having ATEM OSC trigger play loops is an issue for us. When I need to trigger through Ableton Live it wouldn't be much of an issue to send a stop command at the appropriate time. But there is another command: 'Play: Single Clip (true/. We are looking to include a pre-service and post-service specific video that will play through a Hyperdeck. I have been looking through the Protocol Commands for the Hyperdeck Studio, and apparently the 'Play' command used by itself defaults at play all clips (Play from current timecode). We are streaming online and use ATEM OSC to sync up some things with ProPresenter 7 and Ableton Live.